Hello
Wishing you a big welcome to my little crafting place, thank you so much for coming by!
It's been a tricky start to the year for me in several ways and whil;st I've sat at my desk numerous times, tha's as far as it gets.
So I thougjty I'd share something my Hubby has made for me with his new 3D printer.
When I'm die cutting small items for a project and maybe need the little pieces in a variety of colours, I usually have a big die-cutting session and cut all the dies in different colours in one go. This tends to mean a lot of small die-cuts that easily get lost. So to try and keep them under control I pop them into whatever small containers (like old glue-pot lids) I have to hand
But now I have these!
You can see my pile of tatty old lids on the top left of the photo
I asked Hubby to make a set of dishes that will stack together. and chose a few colours and finished from his already expanding filament collection
The stacking dishes are about 8cm diameter, some are about 1 cm deep, others about 2cm. The current stack is about 8.5 high  He made a lid too, and here's how they look all stacked together - much better than those tatty lids which kept falling over. don't you think? |
- you can use it to access the store whenever you buy from SpellbindersIt doesn't cost you anything, but I may get a little reward for pointing you there.There's
a UK based shop now, so you can use the 'Visit Our UK Store' button at
the top right of any page on the Spellbinders site
Thank you so much for coming by
