Making Wax Seals. Pour & Scrape Tulips Part 2

 Hello

Wishing you a warm welcome to my little crafting place, thank you so much for coming by!

Today as promised, I'm just catching up because I've finished the seals I showed at the end of my last blog post.

I ended up using a variety of ways to finish the tulip seals I made last time. some were quite a good shape so I left them be, some were just too misshapen so I cut out the rectangle shape and pressed that into a newly poured wax xhape, and for one I actually cut out the tulip section, put that place back into the warmed brass seal and re-stamped into new wax. 

About the top right seal the photo above

 

After cutting around the flower bunch, I heated some gold wax and some blue wax and warmed the stamp a little.  I poured a small amount of gold into the 

the tulip head area and wiped it away before putting the cut-toout piece back into the seal and again scraping away any excess.  This gave the two-tone effect to the seal.  It was stamped into blue wax, I cut around the rectangle, then stamped again into gold wax

To complete I added some extra dimension by gluing on some tiny thread or twine bows

 

  

Just a Note

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  THIS is my Affiliate link to the Spellbinders store 

-  you can use it to access the store whenever you buy from Spellbinders

It doesn't cost you anything, but I may get a little reward for pointing you there.

There's a UK based shop now, so you can use the 'Visit Our UK Store' button at the top right of any page on the Spellbinders site  

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Thank you so much for coming by

 Happy Crafting, Take care of yourself, and please come back soon!

 

 Kathy xx